CUSTOMIZING A MODEL 1950 EASY RISER
THE FOLLOWING OPTIONS ARE AVAILABLE TO CUSTOMIZE THE MODEL 1950 FOR YOUR APPLICATION:
| The standard model 1950 comes with the model 1952 base that clamps onto 6" steel casings with 3 hand screws |
|
| The model 1967 leg base will work with
any size casing or with well seals
NOTE: IF THE LEG BASE SUITS YOUR APPLICATIONS, YOU WOULD PROBABLY BE BETTER OFF WITH THE MODEL 1977. The legs are fully adjustable with simple pinch clutches. No pins or locks to remove, replace and lose.
|
|
| The model 1965 chain strap support is used on casings with 2 piece caps where part of the cap stays on the casing |
|
| The model 1978 hydraulic pinch
wheel tensioner replaces the standard acme threaded rods for pulling in
the pinch wheel. Note: In Northern North America and Scandanavia,
be aware that the hydraulic fluid can become very thick at low
temperatures.
Shown here in wheelbarrow position for wheeling Easy Riser to the well. |
|
| Hydraulic Pinch Wheel Tensioner in place on model 1950 Easy Riser |
|
| The model 1968 Halo is used to support the top end of rigid drop pipe "sticks", used with galvanized or schedule 80 plastic pipe |
|
